SI_SCOPE has built in support for your QUATECH dual port card. Before using

your card with SI_SCOPE please follow the directions in Section1 and then

proceed to Section 2.

1. Install the Quatech drivers from the driver disk that came with your

Quatech card. Refer to the documentation included on your Quatech CD

for more details.

2. Verify that your card is working using HyperTerm or a similar program.

3. Open Device Manager on your system and double click on the entry titled

“Quatech Multiport Serial Devices”

4. Locate the entry for your card and double click on it.

5. On the next dialog box click on the resources tab and write down the

values for the Interrupt Request and Input/Output Range.

6. Click “Cancel”

Now you are ready to launch SCOPECFG from theWindows Start Menu. After

the program loads follow these steps:

1. Select the Settings->Configure Port Parameters menu option.

2. In the Port1 Address field enter the value recorded for the Input/Output

range from section 1 step 5 above.

3. In the Port1 IRQ field enter the value recorded for the Interrupt Request

from section 1 step 5 above.

4. Add eight to the value in the Port1 Address field and enter that value in the

Port2 Address field.

5. Enter the value for the Port1 IRQ field into the Port2 IRQ field and click

Accept.

6. Select the Settings->Configure Board Type menu option.

7. From the “Multiport Board Configuration” dialog choose your Quatech card

type from the drop down menu.

8. Leave the Base Address set at zero and click Accept.

9. Select the Settings->Configure Virtual Driver menu option.

10.From the Configure SI_SCOPE Device Driver dialog enable the Claim

Hardware during O/S Load option and click Accept.