HdwHPS110 Technical Information

• idle1: Not connected/Normal
• idle in connected2: Connected but no user traffic
• Tx/Rx3: Connected and Tx/Rx user traffic 
• Adjust Search Parameters4: Adjusted the search interval to 0x0800 and the search window to 0x0012
• It was measured in idle state.
• w/o Inq (Inquiry) Scan: Disable Inquiry Scan. Apply to 1:1 mode only.
• Power Saving Mode5: It was measured in the connected idle state.
   

Effect Usage of Extended Command Set

1. Plug a HPS-110 into a COM port of PC. And Power it on.
2. Open a Hyper Terminal and set it up.
3. Push the button to enter the setup mode for the HPS-110.
4. After an LED on the HPS-110 is blinking once every second, hit "Enter" key. You will see the current status of HPS-110.
5. Step 5: Execute a command "LW0722<CR>".
6. Execute a command "X" to apply the changes.
   
   * After this, the reset button will not be worked. You have to use "AT+Z" command sequence. For an example, if you want to see the current information, you can use a command "AT+ZV" instead of 'V'. Please refer to the attached document